Great-planes Micro Whizz ARF - GPMA1102 User Manual

WARRANTYGreat Planes®Model Manufacturing Co. box guarantees this kit to be free from defects in both material and workmanship at the date ofpurchase.T

❏ 2. Gather the four pushrods, threaded couplers, clevises,and clevis retainers as shown in the above photograph.❏ 3. Prepare the pushrods for assembl

❏ 1. The areas where you will be mounting your receiver,speed control, and battery must have a thin coating of glueto allow the Velcro to attach.You c

reversing in the transmitter to reverse the servos connectedto those controls. Be certain the control surfaces haveremained centered. Adjust if necess

❏ 2.With all parts of the model installed (ready to fly), placethe model on a Great Planes CG Machine, or lift it at thebalance point you marked.❏ 3.

Ground check the operational range of your radio before thefirst flight of the day. With the transmitter antenna collapsedand the receiver and transmi

❏ 7. Reinforce holes for wood screws with thin CA whereappropriate, such as servo mounting screws.❏ 8. Confirm that all controls operate in the correc

(anticipating rudder corrections that will be required tomaintain heading), remember to throttle back at the top, andmake certain you are on the desir

INTRODUCTION ...2SAFETY PRECAUTIONS...

If you have not flown this type of model before, werecommend that you get the assistance of an experiencedpilot in your R/C club for your first flight

• Whenever just epoxyis specified you may use either30-minute (or 45-minute) epoxy or 6-minute epoxy. When30-minute epoxy is specified it is highly re

51. Fuselage/Wing w/Ailerons2. Horizontal Stabilizer w/Elevators3. Fin w/Rudder4. Carbon Fiber Tail Boom5. Tail Bracket6. Landing Gear 7. Wheels8. Pus

❏ 1. Locate the carbon fiber tail boom and note the pre-cutslot for the pushrods to exit. Cut a piece of 1/16" [1.6mm]balsa 3/4" [19mm] x 4&

❏ 7.With the horizontal stabilizer placed bottom up on a flatsurface, place the tail boom (with the bracket attached) ontop of the stabilizer as shown

❏ 13. Apply CA to the areas where you removed the coveringand into the slot in the stabilizer. Slide the fin/rudder intoposition and place a 90° tool

❏ 4. Locate and test fit the tail skid into the hole you drilledearlier at the forward end of the slot in the bracket under thehorizontal stabilizer.